Click on the above thumbnail for a map during this time period
Replace ZINC in bow thruster
Remove ZINCS from rudder (so it can be cleaned and painted)
Remove covers from through-hulls that have sea cocks
Clean through-hulls
Grease sea cocks
Replace rusty hook on davit with a stainless steel hook
Remove/clean/reinstall speedometer wheel
Replace receptacle for control cord of davit
Replace bracket for hydraulic arm on hatch to upper deck
Replace carbon filter on vent line of holding tank
Replace one-way valve in hose from forward bilge pump
Replace seal in Dripless Shaft Seal*
Clean propeller and rudder thoroughly
Apply PropSpeed (antifouling) to prop and rudder
Install power supply (repaired and brought back w/ us from USA) for flybridge nav computer
Install replacement "automobile" radio/CD/DVD/MP3/I-pod player
Install (two) new speakers in cockpit
Re-install through-hull covers
Re-install ZINCS on rudder
Re-install ZINC on transom
*This simple task turned into a major one when it developed that the seal housing was cracked. The housing had to be replaced, necessitating uncoupling the shaft and sliding it back far enough to remove the old housing and install a new one. As this is written, the old housing is loosened, the shaft has been slid back, the new housing kit has finally arrived, but we are having trouble getting the nut at the end of the shaft loose!
Note added on Nov. 18: all is good. Now all we need is a turn at getting splashed.